When heater housing design and art combines! Meet the new rebuildable coil for the Dabtech Duvo. The dish is made of high quality ceramic with an internal heating element which runs through the base an inside the walls, providing a fully heated experience.
Get ready for the dab rig revolution! This will change your session experience and make you never pick up a conventional bong again.
The 3D Atomizer improves on nearly every aspect of Duvo performance with better flavor, better vapor, and better battery life. Experience an evolution like no other.
Setting Recommendations -
For Original Duvo: Only use on Blue or White setting. Green is acceptable, but not recommended due to burning of concentrate.
For Duvo X - Any heat settings works - White or Green preferred. Low temp dabs can use Red or Blue
-Fully Rebuildable Ceramic Coil and Replaceable Dish
-Directly Heated Ceramic Dish
-Direct Load Dish- No Need For Inserts Unless Desired
-Easy Access for Heater Replacement
-Minimal Contact Between Housing and Heater
-Full Stainless Steel and Ceramic Build
-Copper Screws for Reduced Stress to Coil
-Two Turn Screw Thread
-Bottom and Side Heating
-Larger Vapor and Better Taste
-Faster Warm Up Time
-Easy to Clean
1x Duvo 3D RDA Atomizer
Ceramic Heater Dish Replacement Instructions:
-Use a hex screwdriver to remove or loosen the gold hex screws.
-Remove the Ceramic Heater Dish and put in a new one
-Place the gold hex screws back in and tighten
-Trim off extra heater wire with a clipper
Please ensure you check the screws that hold the heater legs to make sure they are firmly tightened before use. Do not over-tighten them as you risk cutting the wire heater legs!
The Ceramic heater dishes should last up to 3 months before having to be replaced under normal daily use